One would be automatic temperature controller flat on a smooth place'' not'' in order to avoid too close from EAF furnace heat affect electronic components'''' and then remove the short route to the furnace with the power cord into an electric furnace and then'' to the power cord connected to AC 220V'' and furnace controllers are effective electrical connection.
Two. Thermocouple with a wire connected to a temperature controller'' Note'' ± pole can not be wrong check again whether there is installed an error.
Three would be the thermostat to the desired temperature'' connected control box "type" of power'''' At this point turn the power switch into the red light green light to start work.
Four when the muffle furnace first time or long-term disabled again after use and must be oven dried.
Note:
Installation of all electrical distribution equipment and instrumentation through checks and adjustments'' and check the furnace and the voltage is normal'''' has good contact with the maximum temperature never exceeds the limit temperature series product configuration object'' to take the furnace must be cut off power to ensure safety'' furnace should be placed in a dry place to prevent moisture'' use'' leakage and cracking caused by heating refractories such as automatic temperature controller needs to swap places'' need'' to connect the console to avoid damage to the short route vibration meter.
Electric muffle furnace is used for high-melting-point alloys such as steel and iron!
回复删除